Dakota 2WD L4-2.5L VIN P (2001)
Canister Purge Solenoid: Service and Repair
Fig. 3 Duty Cycle EVAP Canister Purge Solenoid
REMOVAL
The solenoid is located at right-rear side of engine compartment.
1. Disconnect electrical wiring connector at solenoid
2. Disconnect vacuum harness at solenoid,
3. Remove 2 support bracket mounting nuts.
4. Remove solenoid and its support bracket from vehicle.
INSTALLATION
The solenoid is located at right-rear side of engine compartment.
1. Position EVAP canister purge solenoid and its mounting bracket.
2. Install mounting nuts and tighten to 8 Nm (75 in lbs ) torque.
3. Connect vacuum harness and wiring connector.