Dakota 2WD L4-2.5L VIN P (2001)
Fig. 7 Leak Detection Pump (LDP) Mounting Screws
10. Remove 3 LDP mounting screws and remove LDP from vehicle.
INSTALLATION
The LDP is located in the engine compartment under the battery tray and Power Distribution Center (PDC). The LDP filter is attached to the outside
of battery tray. The LDP and LDP filter are replaced (serviced) as one unit.
1. Install LDP to bottom of battery tray. Tighten screws to 1 Nm (11 in. lbs.) torque.
2. Carefully install vapor/vacuum lines to LDP. The vapor/vacuum lines and hoses must be firmly connected. Check the vapor/vacuum lines at the
LDP, LDP filter and EVAP canister purge solenoid for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
3. Connect electrical connector to LDP.
4. Install battery tray Refer to Battery for procedures.
5. Install PDC to fender and battery tray (snaps on to battery tray).
6. Install LDP filter to battery tray (one clip).
7. Install connecting hose to bottom of LDP filter.
8. Connect battery temperature sensor pigtail wiring harness.
9. Install battery. Refer to Battery for procedures.
10. Connect negative battery cable to battery.