Dakota 2WD L4-2.5L VIN P (2001)
Throttle Body: Service and Repair
REMOVAL
A (factory adjusted) set screw is used to mechanically limit the position of the throttle body throttle plate. Never attempt to adjust the engine idle
speed using this screw. All idle speed functions are controlled by the powertrain control module (PCM).
1. Remove air duct at throttle body.
Fig. 53 Throttle Body
2. Disconnect throttle body electrical connectors at MAP sensor, IAC motor and TPS (Fig. 53).
INSTALLATION
A (factory adjusted) set screw is used to mechanically limit the position of the throttle body throttle plate. Never attempt to adjust the engine idle
speed using this screw. All idle speed functions are controlled by the powertrain control module (PCM).
1. Clean the mating surfaces of the throttle body and the intake manifold.
2. Install new throttle body-to-intake manifold gasket.
3. Install throttle body to intake manifold.
4. Install four mounting bolts. Tighten bolts to 11 Nm (100 in. lbs.) torque.
5. Install control cables.
6. Install electrical connectors.
7. Install air duct at throttle body.
