dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

PCM - MIL ON, DTC's P0071 or P0135 or P0141 Set|Page 2988 > < Engine Controls - Flash Programming Failure Recovery|Page 2983
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
PCM - MIL ON, DTC's P0071 or P0135 or P0141 Set

NUMBER: 18-011-01

GROUP: Vehicle Performance

DATE: May 11, 2001

SUBJECT:
MIL Illumination (P0071 Battery Temperature Sensor Performance, or P0135 or P0141 Oxygen Sensor Heater Performance)

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software (calibration level 01Cal14b.)

MODELS:
2001

(AB)

Ram Van/Wagon

2001

(AN)

Dakota

2001

(BR/BE)

Ram Truck

2001

(DN)

Durango

2001

(SR)

Viper

NOTE

THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A GASOLINE ENGINE. CALIBRATION LEVEL MUST BE PRIOR TO (LESS
OR LOWER THAN) 2001 CAL14B. CAREFULLY READ THE NOTES BELOW FOR OTHER CONDITIONS RELATED TO THE "OXYGEN
SENSOR HEATER PERFORMANCE" CONDITION.

SYMPTOM/CONDITION:
Customer will experience MIL illumination.

DIAGNOSIS PROCEDURES:

1.

Using the Diagnostic Scan Tool (DRBIII(R)) with the appropriate Diagnostic Procedures, verify all engine/transmission systems are functioning as
designed. If other DTC's are present, record them on the repair order and repair as necessary before proceeding further with this bulletin.

2.

It the condition seen is a MIL "on" and either Diagnostic Trouble Code (DTC) for "Oxygen Sensor Heater Performance" (P0135 OR P0141) is
present, and the vehicle is equipped with a single upstream oxygen sensor system (see table below) perform the repair procedure. If the vehicle is
not included in the table below, perform the repair procedure and follow normal diagnostic procedures to correct the "Oxygen Sensor Heater
Performance" condition.

3.

If the MIL light is "on", and the vehicle calibration level is already at 2001 CAL14B or higher, and the DTC's for "Oxygen Sensor Heater
Performance" (P0135 OR P0141) are present, follow normal diagnostic procedures to correct the problem.

PARTS REQUIRED:

PCM - MIL ON, DTC's P0071 or P0135 or P0141 Set|Page 2988 > < Engine Controls - Flash Programming Failure Recovery|Page 2983