Dakota 2WD L4-2.5L VIN P (2001)
Manifold Absolute Pressure (MAP) Sensor: Service and Repair
REMOVAL
Fig. 42 MAP Sensor Location
Fig. 43 MAP Sensor Mounting And Rubber Fitting
The MAP sensor is mounted to the side of the throttle body. An L-shaped rubber fitting is used to connect the MAP sensor to throttle body.
1. Remove air duct at throttle body.
2. Remove electrical connector at sensor.
3. Remove two MAP sensor mounting bolts (screws).
4. while removing MAP sensor, slide the rubber L-shaped fitting from the throttle body.
5. Remove rubber L-shaped fitting from MAP sensor.
INSTALLATION