Dakota 2WD L4-2.5L VIN P (2001)
10. Remove the upper ball joint nut and separate the ball joint from the knuckle with Remover MB-991113.
CAUTION: When install Remover MB-991113 to separate the ball joint, be careful not to damage the ball joint seal.
11. Remove steering knuckle.
INSTALLATION
1. Position steering knuckle on upper and lower ball joints and install nuts. Tighten lower nut to 127 Nm (94 ft. lbs.). Tighten upper nut to 81 Nm
(60 ft. lbs.) and install new cotter pins.
2. Remove the spring compressor.
3. Install the shock absorber.
4. Install the hub/bearing.
5. Install ABS speed sensor, brake dust shield, rotor and caliper.
6. Install tie rod to steering knuckle arm,
7. Install the wheel and tire assembly.
8. Remove support and lower the vehicle
