Dakota 2WD L4-2.5L VIN P (2001)
3. Align and install overrunning clutch and cam in case (Fig. 196). Be sure cam is correctly installed. Bolt holes in cam are slightly countersunk on
one side. Be sure this side of cam faces rearward (toward piston retainer).
4. Verify that non-threaded hole in clutch cam is properly aligned. Check alignment by threading a bolt into each bolt hole. Adjust clutch cam
position if necessary.
5. Install and tighten overrunning clutch cam bolts to 17 Nm (13 ft. lbs.) torque. Note that clutch cam bolts are shorter than piston retainer bolts.
6. Install new gasket at rear of transmission case. Use petroleum jelly to hold gasket in place. Be sure to align governor feed holes in gasket with feed
passages in case (Fig. 197). Also install gasket before overdrive piston retainer. Center hole in gasket is smaller than retainer and cannot be
installed over retainer.