Dakota 2WD V6-239 3.9L Magnum (1996)
Fig. 12 Ignition Switch Mounting Pad
2. Mount ignition switch to column. If equipped with column shift, shifter must be in Park position and park dowel pin on ignition switch must
engage with column park lock slider linkage.
Fig. 11 Ignition Switch Column Lock Ring
3. To verify ignition switch is in Lock position, flag should be parallel with ignition switch terminals.
4. Apply a small amount of grease to flag and pin, then position park-lock link and slider to mid-travel.
5. Position ignition switch against lock housing face, ensuring pin is inserted into park-lock link contour slot. Torque retaining screws to 17 inch lbs.
6. Install cover to column. Torque retaining screws to 17 inch lbs.
7. On models with tilt column,install tilt lever.
8. Connect ground cable to battery.
9. With key cylinder and ignition in Lock position, insert key cylinder into assembly until it bottoms.
10. Insert key, then push key cylinder inward and rotate key cylinder clockwise to end of travel.
11. Ensure proper operation of all switch and lock functions.
