Dakota 2WD V6-3.7L (2009)
Brake Hose/Line: Removal and Replacement
Rear Brake Line - Brake Hose At Axle to Wheel Cylinder
REAR BRAKE LINES - BRAKE HOSE AT AXLE TO WHEEL CYLINDERS
1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic
brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the
area of repair instead of the entire system.
2. Raise and support the vehicle.
NOTE: If brake line (3) is being replaced
3. Remove the brake line (3) from the brake hose (2) at the axle.
4. Remove the brake line from the clip on the spring bracket.
5. Remove the other end of the line (1) at the wheel cylinder (2).
