Dakota 2WD V6-3.9L VIN X (1997)
3. Disconnect harness from the Controller Anti-Lock Brake (CAB).
4. Remove mounting nuts attaching the assembly to bracket.
5. Lift the assembly upward off studs and remove assembly.
6. Remove the bracket from the HCU.
7. Remove the CAB mounting screws and disconnect the pump motor connector
8. Lift the CAB off the HCU.
INSTALLATION
1. Install the CAB on the HCU.
2. Install the bracket on the HCU.
3. Install the assembly on the mounting studs.
4. Install and tighten the mounting nuts to 12 Nm (102 inch lbs.).
5. Connect the CAB harness.
6. Connect the brake lines to the HCU. Tighten brake line fittings to 16-23 Nm (140-200 inch lbs.).
7. Connect battery.
8. Bleed brake system as outlined in ABS Service and Repair. See: Brake Bleeding/Service and Repair/Antilock Brake System Bleeding
Procedures/W/ Four Wheel Antilock Brakes
