Dakota 2WD V6-3.9L VIN X (1997)
1. Raise vehicle on hoist.
2. Remove bolt securing sensor and shield to differential housing.
3. Remove sensor and shield from differential housing.
4. Disconnect sensor wire harness and remove sensor.
INSTALLATION
1. Connect harness to sensor. Be sure seal is securely in place between sensor and wiring connector.
2. Install O-ring on sensor (if removed).
3. Insert sensor in differential housing.
4. Install sensor shield.
5. Install and torque sensor attaching bolt to 19-29 N.m (170-230 in.
lbs.).
6. Lower vehicle.
