Dakota 2WD V6-3.9L VIN X (1997)
Glove Box Lamp Switch: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND
POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Open the glove box.
Glove Box Lamp And Switch Remove/Install
3. Reach inside and above the glove box opening and unlatch and unplug the glove box lamp and switch wire harness connector.
4. From inside and above the glove box opening, squeeze the retaining tabs on the glove box lamp and switch housing together and push the unit out
through the instrument panel mounting hole.
5. Reverse the removal procedures to install.
