Dakota 2WD V6-3.9L VIN X (1997)
Turn Signal Flasher: Service and Repair
Combination Flasher Replacement
REMOVAL and INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND
POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the fuse access panel by unsnapping it from the left end of the instrument panel.
Combination Flasher Remove/Install
3. Unplug the combination flasher from the junction block.
4. Install the combination flasher by aligning the flasher terminals with the cavities in the junction block and pushing the flasher firmly into place.
5. Connect the battery negative cable.
6. Test the combination flasher operation.
7. Install the fuse access panel.
