Dakota 2WD V6-3.9L VIN X (1997)
8. Remove rear bearing from output shaft.
WARNING: The next step in disassembly involves compressing the direct clutch spring. It is extremely important that proper equipment be
used to compress the spring as spring force is approximately 830 pounds. Use spring compressor tool 6227-1, or equivalent and a hydraulic
shop press with a minimum ram travel of 5 - 6 inches. The press must also have a bed that can be adjusted up or down as required. Release
clutch spring tension slowly and completely to avoid personal injury.
DIRECT CLUTCH, HUB AND SPRING DISASSEMBLY
1. Mount gear-train assembly in shop press.
2. Position Compressor Tool 6227-1, or equivalent on clutch hub. Support output shaft flange with steel press plates as shown and center assembly
under press ram.
3. Apply press pressure slowly. Compress hub and spring far enough to expose clutch hub retaining ring and relieve spring pressure on clutch pack
snap ring.
