Dakota 2WD V6-3.9L VIN X (1997)
5. Install nut to hold clutch master cylinder to dash panel. Tighten nuts to 54 Nm (40 ft. lbs.).
6. Install clutch master cylinder push rod on clutch pedal pin. Secure rod with retaining clip.
7. Raise vehicle.
8. Insert slave cylinder push rod through clutch housing opening and into release lever. Be sure end of rod is securely engaged in release lever. Check
this before installing cylinder attaching nuts.
9. Install and tighten slave cylinder attaching nuts to 23 Nm (200 inch lbs.) torque.
10. Insert clutch fluid line in body clips, if necessary. Verify that fluid line from master cylinder to slave cylinder is properly routed.