Dakota 2WD V8-318 5.2L Magnum (1995)
Front Door Latch: Service and Repair
DOOR LATCH REMOVAL
1. Raise the window glass to the completely closed position.
2. Remove the door trim panel, the waterdam and the noise insulator from the door inner panel.
3. Disconnect the following:
^
Outside handle-to-latch rod from the latch
^
Key lock cylinder-to-latch rod from the latch
Door Latch And Rods
^
Inside handle-to-latch rod from the latch
^
Lock knob-to-latch rod from the latch, if equipped
^
Lock motor-to-latch rod from the latch
Door Latch Removal/Installation
4. Remove the door latch retaining screws from the door inner panel face.
5. Remove the door latch from the door via the access hole in the panel.
INSTALLATION
1. Install the latch striker, if removed.
2. Insert the door latch through the access hole in the panel, position it at the door face panel, and connect the rods to it.
3. Install the latch retaining screws in the door panel face. Tighten the screws to 9 Nm (7 ft-lbs) torque.
4. Test and ensure that the latch operates correctly.
5. Install the door-noise insulator, the waterdam, and the trim panel.