Dakota 2WD V8-4.7L (2008)
Headliner: Service and Repair
Headliner - Installation
INSTALLATION
Club Cab, Without Rear Jumper Seats
CAUTION: Be careful not to crease the headliner.
NOTE: Headliner for Quad Cab model shown. Club Cab similar.
1. Position the headliner (6) in the vehicle through the door opening from which it was removed.
2. Connect the headliner wire harness connector (1) to the center high mounted stop lamp.
3. Raise the rear of the headliner (7) to the roof panel and install the two coat hooks, See: Trim Panel/Service and Repair/Coat Hook - Installation.
4. Raise the front of the headliner to the roof panel and install the sun visor supports (3), See: Sun Visor/Service and Repair/Sun Visor Support -
Installation.
5. Connect the wire harness connector (5) located at the right A-pillar.
6. If equipped, connect the headliner wire harness connector (2) to the inside rear view mirror.
7. If equipped, install the overhead console, See: Console/Service and Repair/Overhead Console - Installation.
8. Install the sun visors (4), See: Sun Visor/Service and Repair/Sun Visor - Installation.
9. If equipped, install the front dome lamp, See: Lighting and Horns/Dome Lamp/Service and Repair/Dome Lamp - Installation.
10. Install the A-pillar trim panels, See: Trim Panel/Service and Repair/Pillar Trim/A-Pillar Trim Panel-Installation.
11. If equipped, install the rear dome lamp, See: Lighting and Horns/Dome Lamp/Service and Repair/Dome Lamp - Installation.
