Dakota 2WD V8-4.7L (2008)
Control Assembly: Service and Repair
A/C Heater Control - Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in an accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel from the instrument panel and disconnect the wire harness connectors (3 and 4) from the A/C-heater control (1)See: Body
and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Center Bezel - Removal.
3. Place the center bezel on a workbench and remove the screws (2) that secure the A/C-heater control to the center bezel.
4. Remove the A/C-heater control from the center bezel.
