Dakota 2WD V8-4.7L (2008)
EGR Control Solenoid: Service and Repair
EGR Valve - Installation
INSTALLATION - 4.7L
1. Clean area at rear of left cylinder head where it joins base of EGR valve.
2. Clean EGR tube where it joins EGR valve.
3. Position new gasket between EGR valve and cylinder head.
4. Position EGR valve to cylinder head. Install and tighten two bolts (5). Torque to 9 Nm (80 in. lbs.).
5. Position new gasket between EGR tube flange and EGR valve assembly.
6. Position EGR tube (1) to side of EGR valve and into intake manifold. Install two bolts (4) finger tight (temporarily).
7. Install EGR tube flange bolt (1) at intake manifold. Torque to 11 Nm (8.5 ft. lbs.).
8. Connect electrical connector (5) to top of EGR valve solenoid (4).
