dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Campaign - Occupant Restraint Controller Module Update|Page 327 > < Campaign - Occupant Restraint Controller Module Update|Page 325
Page 4
background image

e. Record the "Part Number" displayed at the end of the "Restraint flash file for" statement near the top of "Flash ORC" screen for later reference.

8. Download the flash file from the internet to the StarMOBILE. With the StarMOBILE on the "Flash ORC" screen, follow the procedure below:

a. Select "Browse for New File". Follow the on screen instructions.

b. Enter your "User id" and "Password", then select "OK".

c. If the newly downloaded flash file "Part Number" description:

>

is the same as the number recorded in Step 7e, then the ORC is up to date.
Continue with Step 11.

>

is different than the number recorded in Step 7e, then the ORC requires an update. Continue with Step 8d.

d. Highlight the listed calibration on the StarMOBILE screen.

e. Select "Download to Client".

f.

Select "Close" after the download is complete, then select the "Back" arrow.

g. Highlight the listed calibration.

h. Select "Update Controller" and follow the on screen instructions. 

i. When the update is completed, select "OK".

9. Retrieve the ORC software part number. With the StarMOBILE on "Home" screen, follow the procedure below:

a. Select "ECU View".

b. Select "ORC Occupant Restraint" in the list of modules.

c. Select "More Options".

d. Select "ECU Flash".

e. Verify the "Part Number" (displayed at the end of the "Resident flash file for" statement) has been updated to the new part number. If it has

updated, then the flash has been completed successfully.

If the flash was interrupted or failed, repeat the reprogramming procedure.

10. Clear any Diagnostic Trouble Codes (DTCs) as follows:

NOTE

Due to the CCN programming procedure, DTC(s) may be set in other modules (TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.

a. From the "Home" screen select "System View".

b. Select "All DTC's". 

c. "Clear All Stored DTCs" if there are any DTCs shown on the list.

11. Turn the ignition key to the "OFF" position and remove the StarMOBILE vehicle cable, and battery charger from the vehicle.

Campaign - Occupant Restraint Controller Module Update|Page 327 > < Campaign - Occupant Restraint Controller Module Update|Page 325