Dakota 2WD V8-4.7L (2008)
3. Remove the nut (3) that secures the buckle unit to the stud (4) on the rear floor panel (5) near the base of the cab back panel. The stud and nut that
secures the buckle also secures the inboard rear seat mounting bracket to the rear floor panel.
4. Remove the buckle from the stud and the inboard rear seat mounting bracket.
Rear - Club Cab
REAR - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Fold the rear seat cushions up against the cab back panel (1).
2. Remove the screw (3) that secures the rear seat belt buckle anchor (2) to the rear floor panel (4).
3. Remove the buckle from the rear floor.
