Dakota 2WD V8-4.7L (2008)
11. Using a trim stick or another suitable wide flat-bladed tool, gently pry the edges of the upper door striker trim cover (3) away from the headliner
(2) far enough to disengage the two snap clips that secure it to the upper roof rail (1).
12. Remove the two screws (2) that secure the seat belt turning loop and height adjuster (3) bracket to the upper roof rail (1).
13. Remove the front seat belt and retractor from the vehicle as a unit.
Front Outboard - Quad Cab
FRONT OUTBOARD - QUAD CAB
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The following procedure is for replacement of an ineffective or damaged seat belt and retractor unit. The front retractor also includes a
seat belt tensioner. If the front seat belt or retractor is ineffective or damaged, but the seat belt tensioner is not deployed, review the
recommended procedures for handling non-deployed supplemental restraints. See: Air Bag Systems/Service and Repair. If the seat belt
tensioner has been deployed, review the recommended procedures for service after a supplemental restraint deployment before removing the
unit from the vehicle. See: Repairs and Inspections Required After a Collision/Service and Repair.
