dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Seat Belt and Retractor - Removal|Page 6812 > < Seat Belt and Retractor - Removal|Page 6810
Page 5
background image

8. Remove the lower trim (3) from the inside of the B-pillar (1). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar

Trim/B-Pillar Trim.

9. Disconnect the body wire harness connector (6) from the seat belt tensioner initiator on the retractor (7).

10. Disengage the two clips that secure the belt web guide (2) to the B-pillar.
11. Remove the screw (4) that secures the upper retractor bracket to the B-pillar.
12. Remove the screw (5) that secures the lower retractor bracket to the B-pillar.
13. Disengage the tabs on the retractor bracket from the holes in the inner B-pillar.
14. Remove the front seat belt and retractor from the B-pillar as a unit.

Rear Center - Quad Cab

REAR CENTER - QUAD CAB

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.

NOTE: The right side of the rear center seat belt and retractor mounting bracket and the unique, keyed center seat belt lower anchor
buckle/right outboard occupant buckle unit are secured to the rear floor by a common screw, but the lower anchor buckle and the right
outboard occupant buckle can be removed from the mounting bracket and are serviced separately from the seat belt and retractor. The center
anchor buckle and the right outboard occupant buckle are serviced as a unit with their anchor brackets. See: Seat Belt Buckle/Service and
Repair/Seat Belt Buckle - Removal.

Seat Belt and Retractor - Removal|Page 6812 > < Seat Belt and Retractor - Removal|Page 6810