Dakota 2WD V8-4.7L (2008)
8. Reinstall the upper trim (2) onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Installation.
9. Position the seat belt turning loop to the mounting hole in the upper C-pillar.
10. Install and tighten the screw (6) that secures the seat belt turning loop to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Engage the tab on the lower edge of the trim cover (5) in the slot below the screw in the turning loop. Then press the upper edge of the trim cover
over the top of the turning loop until it snaps into place.
