Dakota 2WD V8-4.7L (2008)
Tilt Wheel Handle: Service and Repair
Removal
REMOVAL
1. Remove the tilt lever handle.
2. Remove the steering column opening cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Steering Column Opening Cover - Removal.
3. Remove the lower shroud.
NOTE: Use special care not to pry on the clockspring electrical connector when removing or installing the mounting screw located next to
the clockspring.
4. Remove the two mounting screws (3) from the tilt lever knob release bracket (1).
5. Disconnect the electrical harness plastic mounting tab (2) from the bracket (1).
6. Unsnap the cable (2) from the bracket (1).
7. Remove the end of the cable (2) from the tilt lever knob release bracket (1).