dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Carpet - Removal|Page 6375 > < Carpet - Removal|Page 6373
Page 5
background image

14. Install the outer front seat belt retractor covers, See: Trim Panel/Service and Repair/Outer Front Seat Belt Retractor Cover - Installation.

15. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed

following service of any supplemental restraint system component. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Occupant Restraint Controller (ORC) Verification Test.

Club Cab, With Rear Jumper Seats

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before

attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.

WARNING: To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat

belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace
any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a
damaged or inoperative buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any
child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat
belt or child restraint component. Always replace damaged or faulty seat belt and child restraint components with the correct,
new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.

NOTE: Carpet for Quad Cab models shown. Club Cab similar.

1. For vehicles equipped with a manual shift transmission, remove the cutout (2) from the carpet for the shifter assembly.
2. Position the carpet (1) in the vehicle.

Carpet - Removal|Page 6375 > < Carpet - Removal|Page 6373