Front Crankshaft Oil Seal - Removal - Dakota 2WD V8-47L Flex Fuel (2009)
Front Crankshaft Seal: Service and Repair
Front Crankshaft Oil Seal - Installation
INSTALLATION
CAUTION: To prevent severe damage to the Crankshaft, Damper or Special Tool 8512A, thoroughly clean the damper bore and the
crankshaft nose before installing Damper.
1. Using Seal Installer 8348 and Damper Installer 8512A (2,3), install crankshaft front seal.
2. Install vibration damper See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair/Vibration Damper -
Installation.
3. Install radiator cooling fan and shroud See: Cooling System/Radiator Cooling Fan/Fan Clutch/Service and Repair/Removal and
Replacement/Viscous Radiator Fan Clutch - Installation.
4. Install upper radiator hose.
5. Install A/C compressor and tighten fasteners to 54 Nm (40 ft. lbs.).
6. Install accessory drive belt refer See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Installation.
7. Refill cooling system See: Cooling System/Service and Repair.
8. Connect negative cable to battery.