Dakota 2WD V8-4.7L Flex Fuel (2009)
Brake Light Bulb: Service and Repair
Tail Stop Turn Lamp Bulb - Removal
BULB
NOTE: The rear lamp unit contains two bulbs: park/stop/turn signal/side marker and backup. The service procedures for each bulb are the
same, only the bulb sizes and types may differ.
1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit (1) from the end of the quarter panel. See: Service and Repair/Tail Stop Turn Lamp - Removal.
3. Disconnect the wire harness connector (4) from the park/stop/turn signal/side marker (2) or the backup (3) bulb socket on the back of the lamp
housing.
4. Firmly grasp the socket on the back of the housing and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the socket and bulb straight out from the keyed opening in the housing.
6. Pull the base of the bulb straight out of the socket.
