Dakota 2WD V8-4.7L Flex Fuel (2009)
1. Position the lower anchor bracket (4) to the floor panel and the cab back panel (2) under the right rear seat cushion.
2. Loosely install the two screws (3) that secure the bracket to the cab back panel.
3. Install and tighten the two screws (1) that secure the bracket to the floor panel. Tighten the screws to 3 Nm (30 in. lbs.).
4. Tighten the two screws that secure the bracket to the cab back panel. Tighten the screws to 23 Nm (17 ft. lbs.).
5. Restore the floor carpet under the rear seat cushion to the base of the cab back panel.
Tether Anchor (Club Cab) - Installation
TETHER ANCHOR - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
NOTE: The following procedure applies only to the center upper child tether anchor used on all club cab vehicles.
1. Position the child tether anchor (1) through the access hole in the cab back trim panel (2) onto the upper cab back panel reinforcement (3).
2. Install and tighten the screw (5) that secures the child tether anchor to the cab back. Tighten the screw to 14 Nm (10 ft. lbs.).
3. Fold the access door (4) back against the cab back trim panel to conceal the tether anchor.
Tether Strap (Club Cab) - Installation
TETHER STRAP - CLUB CAB
