Dakota 2WD V8-4.7L VIN J (2005)
Rear Door Hinge: Service and Repair
Door - Rear
HINGE
REMOVAL
NOTE:
-
It is not necessary to remove the door to replace the hinges if they are replaced one at a time.
-
A suitable body sealant should be used when removing or moving the hinges.
1. Open the front door.
2. Remove the lower b-pillar trim (4). Refer to Trim Panel.
3. Using a grease pencil or equivalent, mark the location of the door hinges on the door.
NOTE: The epoxy bonded washers do not need to be separated from the hinges. If the washers are removed, the door may need to be re-adjusted.
4. Support the door with a suitable lifting device and remove the two nuts (2) and two bolts (1) that secure the door to the hinges.
