Dakota 2WD V8-4.7L VIN J (2005)
3. Unsnap the trim cover (4) from the front seat belt (6) turning loop.
4. Remove the screw (5) that secures the seat belt turning loop to the height adjuster (2) on the upper B-pillar.
5. Remove the seat belt turning loop from the height adjuster.
6. Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the upper B-pillar trim panel (3) to the B-pillar (1) and remove
the trim panel.
INSTALLATION
1. Slide the upper retaining tab of the upper B-pillar trim panel (3) into the hole in the B-pillar (1) and engage the retaining tabs that secure the trim
panel to the B-pillar.
2. Position the seat belt (6) turning loop onto the height adjuster (2) on the upper B-pillar.
3. Install the screw (5) that secures the turning loop to the height adjuster. Tighten the screw to 39 N.m (29 ft.lbs.).
4. Engage the upper edge of a trim cover (4) over the top of the turning loop. Then, squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
