Dakota 2WD V8-4.7L VIN J (2005)
4. Slightly pull out lip portion of piston boot (3) so it protrudes past the bottom of the piston (2) and work lip into outermost groove on caliper
housing (1).
5. Carefully press the lip (3) into the groove with a suitable tool (4) Avoid using sharp-edged tools This will ensure that the lip is nested into the
groove all around before pushing the piston into the bore.
6. Press the piston fully into the bore using special tool C3716-A seal installer (3) with C-4171 Handle (1).
7. Once the piston is pressed into the bottom of the bore, Check to see that the dust boot bellows are not inflated with air. If needed, push in between
the dust boot and piston to expel any trapped air.
INSTALLATION
NOTE: Petroleum based grease should not be used on any of the rubber components of the caliper, Use only Non-Petroleum based grease.
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807® grease.
