Dakota 2WD V8-4.7L VIN J (2005)
3. Install the brake line (2) to the axle stud.
4. Install the brake lines (1&3) into the brake hose (2).
5. Lower the vehicle and remove the support.
6. Bleed the brake system.
FRONT CALIPER HOSE
1. Install the brake hose (6) in position.
2. Install the mounting bracket bolt (3) at the frame, tighten to 14 Nm (125 inch lbs.).
3. Install the brake line (1) into the junction block (2) and tighten to 14 Nm (125 inch lbs.) If removed.
4. Install the brake line (1) into the brake hose (6) and tighten to 14 Nm (125 inch lbs.).
5. Install the brake hose banjo bolt (4) Use new copper washers (5) at the caliper and tighten to 28 Nm (250 inch lbs.).
6. Remove the support and lower the vehicle.
7. Bleed the brake system.
