Dakota 2WD V8-4.7L VIN J (2005)
7. Install the clutch plate (2) onto the compressor shaft.
8. Install the compressor shaft bolt (1). Tighten the bolt to 19 N.m (168 in. lbs.).
NOTE: The shims may compress after tightening the shaft bolt. Check the air gap in four or more places to verify the air gap is correct. Spin the
pulley before performing a final check of the air gap.
9. With the clutch plate assembled tight against the shim(s), measure the air gap between the clutch plate and the pulley and bearing assembly faces
with a feeler gauge. The air gap should be between specifications. If the proper air gap is not obtained, add or subtract shims as needed until the
desired air gap is obtained.
10. Install the bolts that secure the A/C compressor to the engine.
11. Connect the engine wire harness connector to the A/C compressor clutch coil.
12. Install the accessory drive belt.
13. Reconnect the negative battery cable.
