Dakota 2WD V8-4.7L VIN J (2005)
19. Position the blower motor (4) into the HVAC housing (6).
20. Install the three screws (5) that secure the blower motor to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
NOTE: Make sure that all HVAC wire harness leads are correctly routed through the wiring retainers.
21. Install the HVAC wire harness (1) onto the HVAC housing.
22. Connect the HVAC wire harness to the blower motor resistor (2), recirculation door actuator (3) and the blower motor.
23. Align the blend door pivot lever (1) with the blend air door pivot shaft (2) located on the top of the HVAC housing (3).
NOTE: Make sure that the pivot lever retaining tab is fully engaged to the blend-air door pivot shaft.
24. Install the blend door pivot lever into the blend-air door pivot shaft.
