Dakota 2WD V8-4.7L VIN J (2005)
Map Light: Service and Repair
REMOVAL
NOTE: On vehicles equipped with an optional overhead console the standard front dome lamp is replaced by two combination dome and reading lamps
that are integral to the console housing. Each of these lamps is controlled by the door ajar switches on the courtesy lamp circuit, but also are
independently controlled by a switch that is activated by depressing the lamp lens. The bulb types and service procedures are identical for both of these
lamps.
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console (3) from the headliner.
3. Firmly grasp the back of the reading lamp bulb socket (1) and unsnap it from the overhead console lamp housing.
4. Pull the socket and bulb (2) straight out from the keyed opening in the lamp housing.
5. Pull the base of the bulb straight out of the socket.
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the
socket and/or the lamp wiring.
NOTE: On vehicles equipped with an optional overhead console the standard front dome lamp is replaced by two combination dome and reading lamps
that are integral to the console housing. Each of these lamps is controlled by the door ajar switches on the courtesy lamp circuit, but also are
independently controlled by a switch that is activated by depressing the lamp lens. The bulb types and service procedures are identical for both of these
lamps.
1. Align the base of the overhead console reading lamp bulb (2) with the socket (1).
2. Push the bulb straight into the socket until the base is firmly seated.