Dakota 2WD V8-4.7L VIN J (2005)
8. Remove the upper shroud from the lower shroud and the steering column.
9. Remove the one center screw that secures the lower shroud to the steering column (4).
10. Remove the lower shroud from the steering column.
11. Disconnect the wire harness connector (2) from the back of the multi-function switch housing (1).
12. Remove the two screws (4) that secure the switch to the multi-function switch mounting housing (3).
13. Grasp the switch control stalk and pull it toward the left side of the vehicle to remove the switch from the mounting housing.
INSTALLATION
1. Slide the multi-function switch (1) into the multifunction switch mounting housing (3) from the left side. Be certain that the alignment pins on the
top and bottom of the switch are properly engaged in the channels of the mounting housing.
2. Install and tighten the two screws (4) that secure the switch to the mounting housing. Tighten the screws to 2 N.m (20 in. lbs.).
3. Reconnect the wire harness connector (2) to the back of the switch.
