Dakota 2WD V8-4.7L VIN J (2005)
2. Install new belt. Route the belt around all pulleys except the idler pulley (5). Rotate the tensioner arm until it contacts its stop position. Route the
belt around the idler (5) and slowly let the tensioner rotate into the belt. Make sure the belt is seated onto all pulleys.
3. With the drive belt installed, inspect the belt wear indicator. On 4.7L Engines only, the gap between the tang and the housing stop (measurement
A) must not exceed 24 mm (0.94 inches). If the measurement exceeds this specification replace the serpentine accessory drive belt.
