Dakota 2WD V8-4.7L VIN J (2005)
42RLE Fluid Fill
FLUID LEVEL CHECK USING SCAN TOOL
NOTE: Engine and Transmission should be at normal operating temperature before performing this procedure.
1. Start engine and apply parking brake.
2. Connect scan tool and select transmission.
3. Select sensors.
4. Read the transmission temperature value.
5. Compare the fluid temperature value with the chart.
6. Adjust transmission fluid level shown on the dipstick according to the 42RLE Fluid Temperature Chart. Use only Mopar(R) ATF+4, Automatic
Transmission Fluid.
7. Check transmission for leaks.
Fluid/Filter Service - 42RLE
FLUID/FILTER SERVICE
NOTE: Only fluids of the type labeled Mopar(R) ATF+4, Automatic Transmission Fluid, should be used in the transmission sump. A filter change
should be made at the time of the transmission oil change. The magnet (on the inside of the oil pan) should also be cleaned with a clean, dry cloth.
NOTE: If the transmission is disassembled for any reason, the fluid and filter should be changed.
1. Raise vehicle on a hoist. Place a drain container with a large opening, under transmission oil pan.
NOTE: One of the oil pan bolts (5) has a sealing patch applied from the factory. Separate this bolt for reuse.
2. Loosen pan bolts and tap the pan at one corner to break it loose allowing fluid to drain, then remove the oil pan.
3. Install a new filter and O-ring on bottom of the valve body and tighten retaining screws to 5 Nm (40 inch lbs.).
NOTE: Before installing the oil pan bolt (5) in the bolt hole located between the torque converter clutch on and U/D clutch pressure tap circuits, it
will be necessary to replenish the sealing patch on the bolt using Mopar(R) Lock & Seal Adhesive.
4. Clean the oil pan and magnet. Reinstall pan using new Mopar(R) Silicone Adhesive sealant. Tighten oil pan bolts to 19 Nm (165 inch lbs.).
5. Pour four quarts of Mopar(R) ATF+4, Automatic Transmission Fluid, through the dipstick opening.
6. Start engine and allow to idle for at least one minute. Then, with parking and service brakes applied, move selector lever momentarily to each
position, ending in the park or neutral position.
7. Check the transmission fluid level and add an appropriate amount to bring the transmission fluid level to 3 mm (1/8 inch) below the lowest mark
on the dipstick.
8. Recheck the fluid level after the transmission has reached normal operating temperature (180°F.).
9. To prevent dirt from entering transmission, make certain that dipstick is fully seated into the dipstick opening.
Transmission Fill - 42RLE
TRANSMISSION FILL
To avoid overfilling transmission after a fluid change or overhaul, perform the following procedure:
