Dakota 2WD V8-4.7L VIN J (2005)
Turn the ignition off.
Remove the Fuel Pump Relay from the IPM.
Disconnect the Fuel Pump Module harness connector.
Measure the resistance of the (N1) Fuel Pump Relay Output circuit from the relay connector to the fuel pump module connector.
Is the resistance below 5.0 ohms?
Yes
-
Replace the Fuel Pump Relay.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test
No
-
Repair the open in the (N1) Fuel Pump Relay Output circuit.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test
