dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Controls - Generic PCM programming Procedure|Page 2001 > < Engine Controls - Generic PCM programming Procedure|Page 1999
Page 8
background image

a.

Select "ECU View"

b.

Scroll through the list of controllers and highlight the WCM.

c.

Select "Misc. Function".

d.

Highlight "PCM Replaced".

e.

Select "Start"

f.

Follow the on screen instructions. Select "Next" after each step. Select "Finish" after completing the last step.

g.

When complete proceed to Step # 16.

15.

Program the VIN into the PCM.

a.

Scroll through the list of controllers and highlight the PCM.

b.

Select "Misc. Function".

c.

Highlight "Check PCM VIN".

d.

Select "Start"

e.

Follow the on screen instructions. Select "Next" after each step. When the window appears with 17 boxes, select "Show Keyboard". Place
the cursor to the right of the last box and then backspace to delete the boxes from the window. Enter the VIN. Select "Finish" after
completing the last step.

f.

Unplug the scan tool from the Data Link Connector.

g.

At the "Vehicle Disconnected" screen, press "OK".

h.

Connect the scan tool to the Data Link Connector and verify that the VIN is visible at the top of the "Home" screen.

16.

Is the vehicle is equipped with a 3.7L or 4.7L engine?

a.

Yes >> go to Step # 18.

b.

No >> go to Step # 17.

17.

Using the StarSCAN at the "Home" screen:

a.

Select "ECU View"

b.

Scroll through the list of controllers and highlight the PCM.

c.

Select "Misc. Function".

d.

Highlight "Learn ETC".

e.

Select "Start"

f.

Follow the on screen instructions. Select "Next" after each step. Select "Finish" after completing the last step.

NOTE:

Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "ECU View" from the Home screen, record the DTC's, and erase these
DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.

NOTE:

The following step is required by law.

18.

Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 1). **

POLICY:

Engine Controls - Generic PCM programming Procedure|Page 2001 > < Engine Controls - Generic PCM programming Procedure|Page 1999