Dakota 2WD V8-4.7L VIN J (2005)
b. A screen will appear requesting a "COLD BOOT".
c. Follow the on screen instructions by selecting the "F4" key.
d. When the DRBIII(R) reboots to the MAIN MENU, proceed to Step # 2
2. With the ignition switch in the "RUN" position, determine the original part number of the PCM currently in the vehicle. Using the DRBIII(R) select:
a. "DRBIII(R) Standalone"
b. "1998 - 2007 Diagnostics"
c. "All (Except Below)"
d. "Engine"
e. "Module Display"
f.
Record the "PCM part # on the repair order for later reference.
3. Connect the DRBIII(R) to TechCONNECT. Open TechTOOLS and verify that the "DRBIII(R) Status: Connected" message is in the upper right
corner of the TechTOOLS screen.
4. Enter the "PCM part # " recorded in Step #2 in the "Parts Criteria" area and select "Show Updates". TechTOOLS will populate the available updates.
5. Select the calibration.
6. Select the "DRBIII radio button which is next to the "Download/Update" button.
7. Select the "Download/Update" button.
8. Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT. When the
download/update process from TechCONNECT to the DRBIII(R) is complete, proceed to Step # 9.
9. Disconnect the DRBIII(R) from TechCONNECT.
10. Open the hood and install a battery charger. Using a voltmeter, verify that the charging rate provides 13.2 - 13.5 volts. Set the battery charger to
continuous charge. Do not allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is
complete.
NOTE:
Do not allow the charging voltage to climb above 13.5 volts during the flash process.
11. If the vehicle is a 2004 or 2005 KJ:
a. Turn the ignition switch to the "OFF" position.
b. Disconnect the electrical harness connector from the Controller Anti-Lock Brake (CAB) module.
c.
Turn the ignition switch to the "ON" position, do not start vehicle.
12. Connect the DRBIII(R) to the vehicle.
13. Turn the ignition to the "Run" position (engine not running).
14. Download the flash from the DRBIII(R) to the vehicle PCM. Using the DRBIII(R) select:
a. "Vehicle Flash"
b. Follow the directions on the DRBIII(R) screen. When the PCM flash process is complete, proceed to the next step.
15. If the vehicle is a 2004 or 2005 KJ:
a. Turn the ignition switch to the "OFF" position.
