Dakota 2WD V8-4.7L VIN J (2005)
a.
Select "ECU View"
b.
Touch the screen to highlight the PCM in the list of modules.
c.
Select "More Options"
d.
Select "ECU Flash"
e.
Record the part number at the top of the "Flash PCM" screen for later reference.
6.
Replace the PCM with the appropriate Generic PCM. Refer to the detailed service information available in TechCONNECT, under: Service Info,
8-Electrical, Electronic Control Module, Powertrain Control Module, Removal.
7.
Program the PCM as follows:
a.
Using the StarSCAN(R) at the "Home" screen, Select "ECU View"
b.
Touch the screen to highlight the PCM in the list of modules.
c.
Select "More Options"
d.
Select "ECU Flash"
e.
Select "Browse for New File". Follow the on screen instructions.
f.
Highlight the appropriate calibration based on the part number recorded in Step 5.
g.
Select "Download to Scantool".
h.
Select "Close" after the download is complete, then select "Back".
I.
Highlight the listed calibration.
j.
Select "Update Controller". Follow on screen instructions.
k.
When the update is complete, select "OK".
l.
Verify the part number at the top of the "Flash PCM" screen has updated to the new part number.
8.
Is "WCM - Wireless Control Module" displayed in the "ECU Overview" screen list of modules?
a.
Yes >> go to Step # 9.
b.
No >> go to Step # 10.
9.
Program the PCM to the Wireless Control Module (WCM).
a.
Highlight the WCM.
b.
Select "Misc. Function".
c.
Highlight "PCM Replaced".
d.
Select "Start"
e.
Follow the on screen instructions. Select "Next" after each step . Select "Finish" after completing the last step.
f.
When complete proceed to Step # 11.
10.
Program the VIN into the PCM.
a.
Scroll through the list of controllers and highlight the PCM.
b.
Select "Misc. Function".
