Dakota 2WD V8-4.7L VIN J (2005)
Seat Heater Control Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the center floor console and remove the base mat.
3. Remove the power outlet panel (5) by grasping the lower access slot (4) and lifting up and rearward to release it from the console.
4. Lay the power outlet panel (3) down to access the module fasteners.
5. Remove the two fasteners securing the module (4).
6. Disconnect the wire harness connector (5) from the heated seat module (4).
7. Remove the heated seat module (4) from the vehicle.
INSTALLATION