dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Air Bag Systems|Driver|Page 5112 > < Air Bag Systems|Driver|Page 5110
Page 3
background image

1. Position the driver airbag (1) close enough to the steering wheel to reconnect the three electrical connections on the back of the airbag housing.
2. When installing the driver airbag, reconnect the two clockspring driver airbag pigtail wire connectors (3) to the airbag inflator connector

receptacles by pressing straight in on the connector. Be certain to engage each keyed and color-coded connector to the matching connector
receptacle. You can be certain that each connector is fully engaged in its receptacle by listening carefully for a distinct, audible click as the
connector latches snap into place.

3. Reconnect the steering wheel wire harness connector (2) for the horn switch to the horn switch feed pigtail wire connector (4), which is located on

the back of the driver airbag housing.

4. Carefully position the driver airbag (1) in the steering wheel (2). Be certain that the clockspring pigtail wires and the steering wheel wire harness in

the steering wheel hub area are not pinched between the driver airbag and the steering wheel armature.

5. From the underside of the steering wheel, install and tighten the two screws (3) that secure the driver airbag to the steering wheel armature.

Tighten the screws to 10 N.m (90 in. lbs.).

6. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed

following service of any supplemental restraint system component.

Assembly & Disassembly

WARNING:

-

TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL
RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, OCCUPANT
CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT
DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO
MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE.
THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.

-

TO AVOID PERSONAL INJURY OR DEATH, SERVICE OF THIS UNIT SHOULD BE PERFORMED ONLY BY
DAIMLER-CHRYSLER-TRAINED AND AUTHORIZED DEALER SERVICE TECHNICIANS. FAILURE TO TAKE THE PROPER
PRECAUTIONS OR TO FOLLOW THE PROPER PROCEDURES COULD RESULT IN ACCIDENTAL, INCOMPLETE, OR

Air Bag Systems|Driver|Page 5112 > < Air Bag Systems|Driver|Page 5110