Dakota 2WD V8-4.7L VIN J (2005)
5. Position the belt web guide (2) to the B-pillar and use hand pressure to press it firmly and evenly until the two clips that secure it snap into place.
6. Reconnect the body wire harness connector (6) to the seat belt tensioner initiator on the retractor.
7. Reinstall the lower trim (3) onto the inside of the B-pillar.
8. Reinstall the upper trim (3) onto the inside of the B-pillar (1).
9. Position the seat belt (6) turning loop onto the height adjuster (2) on the upper B-pillar.
10. Install and tighten the screw (5) that secures the turning loop to the height adjuster. Tighten the screw to 39 N.m (29 ft. lbs.).
11. Engage the upper edge of a new trim cover (4) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
12. Position the seat belt (1) lower anchor to the mounting hole on the outboard side of the front seat cushion frame (2). Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
13. Install and tighten the screw (3) that secures the lower anchor to the seat. Tighten the screw to 39 N.m (29 ft. lbs.).
14. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
Rear Outboard - Club Cab
WARNING: TO AVOID PERSONAL INJURY OR DEATH, DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT
ANCHOR SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER
STRAPS, AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT,
FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT
