Dakota 2WD V8-4.7L VIN J (2005)
5. Position the retractor (1) mounting bracket to the mounting holes in the floor panel inboard of the door sill (4). Be certain that the seat belt
webbing between the retractor and the turning loop is not twisted.
6. Install and tighten the two screws (2) that secure the retractor bracket to the floor panel. Tighten the screws to 39 N.m (29 ft. lbs.).
7. Reconnect the body wire harness connector (3) to the seat belt tensioner initiator on the retractor.
8. Restore the front (5) and rear (4) scuff plates to the door sill over the retractor mounting bracket.
9. Position the inboard (1) and outboard (3) trim cover halves around the seat belt and retractor (2) with the lower end spread open far enough to
engage the snap features that secure the tops of the two halves to each other.
10. Close the lower ends of the trim cover halves together.
