Dakota 2WD V8-4.7L VIN J (2005)
Fluid Pressure Sensor/Switch: Service and Repair
Automatic Transmission 545RFE
Sensor-Line Pressure
SENSOR-LINE PRESSURE
REMOVAL
1. Raise vehicle.
2. Place a suitable fluid catch pan under the transmission.
3. Remove the wiring connector from the line pressure sensor (2).
4. Remove the bolt holding the line pressure sensor (2) to the transmission case.
5. Remove the line pressure sensor (2) from the transmission case.
INSTALLATION
1. Install the line pressure sensor (2) into the transmission case.
2. Install the bolt to hold the line pressure sensor (2) into the transmission case. Tighten the bolt to 11.9 Nm (105 inch lbs.).
3. Install the wiring connector onto the line pressure sensor (2).
4. Verify the transmission fluid level. Add fluid as necessary.
5. Lower vehicle.
Assembly-Transmission Solenoid/TRS
ASSEMBLY-TRANSMISSION SOLENOID/TRS
REMOVAL
