Dakota 2WD V8-4.7L VIN J (2005)
12. Remove the hub/bearing bolts (2) from the knuckle (1).
13. Remove the hub/bearing from the steering knuckle (1).
14. Remove the steering knuckle (1).
INSTALLATION
CAUTION: The ball joint stud tapers must be CLEAN and DRY before installing the knuckle. Clean the stud tapers with mineral spirits to remove
dirt and grease.
1. Install the hub/bearing to the steering knuckle and tighten the bolts (1) to 163 Nm (120 ft. lbs.).
2. Install the knuckle (7) onto the upper (2) and lower ball joints (5).
3. Install the upper (1) and lower ball joint nuts (6). Tighten the nut to 75 Nm (55 ft. lbs.).
4. Remove the hydraulic jack from the lower control arm (4).
