Dakota 2WD V8-4.7L VIN J (2005)
3. Install the lower part of the shock (2) into the lower control arm shock bushing.
4. Position shock module (2) to lower control (6). Install bolt (4) so head of bolt is facing rear of vehicle and hand start nut (3). Tighten the bolt (4)
& nut (3) to 210 Nm (155 ft. lbs.).
5. Install the stabilizer link lower nut (5) to the lower control arm (6). Tighten the nut to 102 Nm (75 ft. lbs.)
6. Insert ball joint (6) in steering knuckle (7) and tighten ball joint nut to 95 Nm (70 ft. lbs.)
7. Reposition the wheel speed wire (5) into the retaining brackets (3).
8. Install the caliper slide pin bolts (2). Tighten to 32 Nm (24 ft. lbs.).
9. Remove the support from the lower control arm outboard end.
10. Install the tire and wheel assembly.
11. Remove the support and lower the vehicle.
